Grbl 3018 Cnc Software Downloads Chronos

For example: typing $112=600 changes the z max rate to 600. Steps/mm needs to be calculated and the easiest way of doing it is by using prusas reprap calulator.To change a setting, type the identifier of the parameter (for example $100 for x steps) '=' and then the new value. You should see a message like this 'Grbl x.xj ' if you dont see the message, make sure that your are connected to the correct port and use the baudrate of 115200.Type '$$' and a list of commands should appear, like this:$100=250.000 (x, step/mm) $101=250.000 (y, step/mm) $102=3200.000 (z, step/mm) $110=500.000 (x max rate, mm/min) $111=500.000 (y max rate, mm/min) $112=500.000 (z max rate, mm/min) $120=10.000 (x accel, mm/sec^2) $121=10.000 (y accel, mm/sec^2) $122=10.000 (z accel, mm/sec^2) $130=200.000 (x max travel, mm) $131=200.000 (y max travel, mm) $132=200.000 (z max travel, mm)The most important part to change is the steps/mm. To communicate with your board you need to open the arduino ide serial monitor. Now with firmware on your board you need to adapt grbl to your specific machine.

Hitting the 'Board Info' option leaves me with BN: unknown VID: 1A SN: Upload any sketch to obtain it. I've followed the instructions here on this thread, but when I try to find the controller-board in the Arduino IDE - program, I just can't find anything usable. I've been searching high snd low, in order to find a usefull CNC-program to act between my mill and my linux-computer, but all I could find either didn't work or required a com port as interface.

Operating system is Manjaro (latest version, as it's a rolling release) I really hope there's a linux-'guru' somewhere that can guide me through this process, as I'm a totally newbee to linux, but I would really HATE to be forced back to Windows again.

Grbl 3018 Cnc Software Downloads Chronos